德国Hetronik 加热控制板
型号列表:
HC100
HC200
HC300
HC400
HC500
HC-HMIS
HCMs
The HC100 is design to control short wave IR lamps (Halogen, Tungsten, NIR) at 400V.
Each HC100 HC-block can control 9 channels up to 4000 watts per channel.
This systems unique direct-mount bus bar system eliminates fusing for the power voltage supply. In addition the power output and return phase are protected with super fast blow fuses mounted directly on the HC block. This powerful robust compact system will reduce panel space and installation time while maintaining optimum control of the lamps.
|
The HC200 is the first designed multiple channel heat control. The HC 200 controls multiple 230V constant resistive heaters such as quartz, ceramic, incoloy and tungsten.
This high end controller has the diagnostic feature, open heater detection, if using single or multiple heaters in a zone. The HC200 measures each zone wattage and compares this to the expected or known wattage of the zone. If the measured wattage does not equal the expected wattage an alarm is triggered. This provides the operator with critical information of single heater status or failure.
The power switch (triac) of each channel output is protected against short circuit by a super fast blow fuse located in a fuse holder. The fuse holder is located on the front of the HC block for quick accessed and exchange with out opening the HC block. This feature reduces failures, increases uptime and overall production.
|
HC-block for heaters with 400...480 Volts (phase/phase) and 4000...4800 Watts each of its 24 channels.
HC-block for quartz and ceramic heaters with 230...480 line voltage (phase/neutral or phase/phase).
For 24 control outputs for 24 channels
Max. 400 amps/phase.
|
Low cost system for quartz and ceramic heaters and short wave lamps with 230Volts (phase/neutral).
Power outputs card with 8 and 16 channels and 2000/2500 and 1000 Watts each channel Content will online soon.
|
Operator interfaces that can be interfaced direcly with the HC-blocks (no PLC needed)
|
HC Modules to be interfaced between a host system and HC-blocks. Acting as protocol or bus gateway to the HC specific HC-NET protocol or acting as temperature controller.
|
|
|