德国风凯FUNKE换热器板式换热器
螺栓设计(板框)Bolted Design (plate & frame)
Plate Heat Exchangers
FUNKE - heat transfer plates are characterised by optimum embossing resulting in high heat transfer coefficients. This permits low-cost and optimum adaption to the respective application conditions Our product range includes single-pass and multi-pass plate heat exchangers with heat exchange surface up to 2000 m².
FP/FPS
Technical data:
- Heat exchange surface per plate: 0,04 - 3 m²
- Max. design pressure: 25 bar
- Max. design temperaturer: 195°C
Safety:
Our plates are provided with double gaskets at the inlet and outlet which prevent mixing of the two media. If designed as safety heat exchanger, double plates are provided with a special sealing system.
Plate material:
- standard: stainless steel 1.4301/AISI 304, 1.4401/AISI 316
- Optionally: 1.4539, 254 SMO, titanium
Gasket material:
- NBR (nitrile-rubber)
- EPDM (ethylene-propylene-rubber)
- Viton(fluorine-rubber)
- Further materials on request
Special series:
- Safety heat exchangers (FPSS)
- Stainless steel design for food and FDA applications
- Compact double PHE-units including cocks and valves
- Design with welded cassettes (FPG)
Brazed Design
GPLK
(heat transfer plates with V - corrugation)
Application:
Mainly for heating, air-conditioning, motor cooling, heat recovery. Globally to be used with different media.
Technical data:
- Max. operating pressure: 30bar
- Max. operating temperature: +200°C
Material:
- Plates: 1.4401 / AISI 316
- Solder: copper
- nickel (NPLK)
TPL
(turbo-plates in the flow gap)
Application:
Especially developed for the requirements of plant and mechanical engineering (f. inst. engine/ motor oil cooling). Small sizes by high heat transfer rate at higher viscosity! Globally used with different media.
Technical data:
- Heat exchange surface per plate: 0.035 - 0.286 m²
- Max. operating pressure: 30bar
- Max. operating temperature: -100°C...+200°C
Material:
- plates: 1,4401 / AISI 316
- solder: copper 99.9%
One-pass design Two-passes design Three-passes design
|